Thursday, February 28, 2008
Hip tip: Joining corners by using FILLET
Daily Autocad: "Sometimes, there can be un-joined corners or some corners that are overflowing through the lines that are connecting at that corner. There is a very easy way to correct them by using TRIM command. FILLET R=0."
Subscribe to:
Post Comments (Atom)
2 comments:
The Fillet command is a great command that can help you do many different corners. I am glad that there is a command that can do this because otherwise it would be a pain to fix any corners in the project. Sometimes I forget about the fillet command and it is too bad.
I thought this was going to be some crazy tip but then I read it and thought "well, duh."
Post a Comment